S 108.00-CD AWG30 Wire pre-attached
green, length appr. 500 mm (1.6ft)
Fixturing Example
For the installation of the receptacles the mounting plate requires precise drilling. In the fixture business there are some typical base materials used for the pin plates
which are different in drill bit diameters and machining parameters. The table below is showing the recommended drill diameter and the order numbers needed
when ordering drill bits from us. For machining parameters please consult factory.
Receptacle with Press-Ring, pressed into Plate Material
Material CEM1 (also called EP105 ) in. mm N.A.
FR4 (G10, Hgw 2372 or Hgw 2372.1)
Drill-ø
.0311 in. 0,79 mm
.0315 in. 0,80 mm
Part No.
500-0079
500-0080
Press-Ring or Stop Ring used as a Collar
Material CEM1 (also called EP105 )
FR4 (G10, Hgw 2372 or Hgw 2372.1)
